Parisi Mechanical Inwall Cistern's are designed for effortless installation. Unlike inwall cisterns of the past, this Parisi model features front actuation and push plate access, with adjustable height for added convenience. 

With full frame, low level & Pneumatic options; as well as a comprehensive range of parts for the Parisi In Wall Cistern, we have a solution. This will ensuring you have everything you need for a seamless installation and a well-equipped bathroom.

See below our ten step guide to see how installation and maintained of this cistern is made a breeze with Parisi and Robertson Trade.

Determine the amount to trim from the flush pipe by measuring the height from the floor to the flush pipe of the W.C. and the height of the Parisi flush pipe from the finished floor.

Apply lubricant to the O-Rings on the cistern to ensure a secure seal.

Record the cavity measurements provided above, and drill wall anchors into the masonry or wall.

Ensure the cistern is level, then install the fitting into the cistern.

Detach the protective panels from the installation duct and remove the cover of the inwall cistern.

Seal the mini tap (isolation valve) using suitable material. Ensure that the mini tap is inside the cistern and tightened with back nut.

Connect the flexi-hose to the mini tap (isolation valve) and inlet valve. 

Reinstate the inner cistern cover and panel. 

Fill in the cavity, ensuring that the maximum of 3mm spacing around the push panel. 

Plumbers Picks 

Parisi Inlet Valve		Parisi Lever Block Rods
Parisi Outlet Valve Washer		Parisi Mechanical Outlet Valve
Parisi Blade Mechanical Push Plate		Parisi Lever Block

Contact Information

42 Vestey Drive, Mt Wellington, Auckland 1060 

09-573-0490 

parts@robertson.co.nz